Single Stud Type Junction Blocks 200A Outer Screw(M8) Outer Screw(M8) Flange Mounting Black

Great for the price, well built, just don??t torque the hell out of it, been using the same 2 for awhile now

Item looks nice and well built but i have not used it yet.

For surface mount applications these will work well. The nuts thread smoothly onto the studs and lock washers are provided. Four small screws are also provided for mounting.

I use a crane to hoist objects to a mezzanine in my garage. I ordered these doohickeys to make the connection from crane leads to power supply. They are solid and substantial. Now the electrons make their dates and the current flows like its on a cruise to the Caribbean baby.
The price, time to deliver, quality, and general aesthetics make me beam with happiness and I dig that feeling.
Buy it, try it, and try not to fry it.

I bought these so i could move the deep cycle battery in my row boat up to the front to distribute the weight better. I had to run longer power cables back from battery and use these to connect the trolling motor with the extension cables to the battery. They work slicker than snail snot! Good product!

I used this a junction block to split power front and rear for winch connections. Seems to work well.

Needed disconnect terminal by the fuse block on a boat rewiring project. These did the trick quite nicely

IT WAS AVAILABLE, PRICE WAS REASONABLE, I HAD A SPECIFIC NEED FOR SUCH AN ITEM, HAD NO IDEA ANYTHING LIKE THIS EXISTED. WAS HAPPY TO FIND THAT IT DOES. TO KEEP THIS AS SIMPLE AS POSSIBLE. THE POWER OUTPUT FROM A FORD 2G ALTERNATOR, GOING TO THE STARTER SOLENOID RELAY (SEE IMAGE 4) CONSISTS OF 3 LARGE (10 AWG) WIRES REDUCED TO A SMALLER 14 AWG FUSIBLE LINK ( A SLOW BURNING FUSE IN WIRE FORM ). OVER TIME, THEY NEED TO BE REPLACED, BUT YOU CAN'T REPLACE JUST THE FUSIBLE LINK, YOU HAVE TO BUY THE WHOLE HARNESS. WITH THE ITEM BEING DISCUSSED, I WAS ABLE TO FABRICATE A WAY TO REPLACE JUST THE FUSIBLE LINK. I COULD HAVE USED JUST A STANDARD 3/8" BOLT, NUT AND WASHER SET UP, BUT NO CLEAN, SAFE WAY TO INSULATE IT OTHER THAN ELECTRICAL TAPE. THIS STUD JUNCTION IS PERFECT FOR THE JOB.